Use the ont-srvprofile command to create and enter the GPON ONT service profile mode or enter the created GPON ONT service profile mode. OLT(ont-lineprofile-10)# gem mapping 11 1 vlan-id 100 OLT(ont-lineprofile-10)# gem add 11 tcont 1 OLT(ont-lineprofile-10)# tcont 1 dba-profile-id 10 OLT(config)# ont-lineprofile profile-id 10 It is mainly used to configure DBA, T-CONT, and GEM Port related information.Ĭreate a GPON ONT line profile, ID is 10, and bind T-CONT 1 to the DBA profile 10 in this line profile. The ont-lineprofile describes the binding relationship between the T-CONT and the DBA template, the QoS mode of the service flow, and the mapping between the GEM Port and the ONT side. There are 5 kinds of dba-profile types, please refer to the User Guide to check the details. Therefore, select a DBA profile of the proper bandwidth type and configure proper bandwidth according to the service types and total user count of the ONT. Note: The DBA implementation is based on an ONT. Set the profile ID to 10, profile type to type3, assured bandwidth to 8 Mbit/s, and maximum bandwidth to 20 Mbit/s. If the existing DBA profiles in the system do not meet the requirements, run the dba-profile command to add a DBA profile.Ĭreate the same DBA profile for different types of services. Run the show dba-profile command to query existing DBA profiles in the system. OLT(interface-ge)# vlan hybrid 9 tagged 100 Here we add GE9 port to the VLANs as the uplink port. You need to add the uplink port to the VLAN we just created, and set the port type according to the requirement. The uplink port of the OLT is the one connected to the service provider. We will follow the below process to finish the configuration:Īccording to the data plan, we will need a vlan to transmit the Internet access services. Service profie: A service profile provides the service configuration channel for the ONT that is managed by using optical network terminal management and control interface (OMCI).Line profie: A line profile describes the binding between the T-CONT and the DBA profile, the QoS mode of the traffic stream, and the mapping between the GEM port and the ONT side service. A T-CONT is bound to a DBA profile for dynamic bandwidth allocation, improving upstream bandwidth utilization.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |